BKSVM - EPOXY CATALYST, 22-7589
- MSDS: BKSVM
- Manufacturer: STERLING LACQUER MFG CO INC
- Product Name: EPOXY CATALYST, 22-7589
- National Stock Number: 8010-00-948-6733
Product Identification
Product ID:EPOXY CATALYST, 22-7589
MSDS Date:12/01/1989
FSC:8010
NIIN:00-948-6733
Kit Part:Y
MSDS Number: BKSVM
Responsible Party
ST LOUIS, MO 63139
US
Emergency Phone: 314-776-4450
Info Phone: 314-776-4450
Preparer: P. D. MOORE
Cage: 60003
Contractor
Telephone: 314-776-4450
Cage: 60003
Ingredients
ISOPROPYL ALCOHOL (SARA III)
CAS: 67-63-0
RTECS: NT8050000
Fraction By Weight: 9%
OSHA PEL 400 PPM/500 STEL
ACGIH TLV: 400 PPM/500STEL;9192
1.3 MM HG 68F)
CAS: 2807-30-9
RTECS: KM2800000
Fraction By Weight: 44%
N-BUTYL ALCOHOL (SARA III)
CAS: 71-36-3
RTECS: EO1400000
Fraction By Weight: 15%
OSHA PEL 100 PPM
ACGIH TLV: S, C 50 PPM; 9293
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
TOLUENE (SARA III)
CAS: 108-88-3
RTECS: XS5250000
Fraction By Weight: 5 - 10%
OSHA PEL 200 PPM/150 STEL
ACGIH TLV: 50 PPM; 9293
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
5.47 LB/GL (655 G/L)
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALE: IRRITATION TO THE RESPIRATORY
TRACT (NOSE, THROAT, LUNGS) AND/OR NARCOSIS. SKIN/EYE: IRRITATING.
MAY INJURE EYE TISSUE IF NOT PROPERLY REMOVED. SKIN ABSORB: SLIGHT
IRRITATION DUE TO SOLVENTS. INGEST: MODERATELY TOXIC. MAY CAUSE
NAUSEA, VOMITING AND DIARRHEA.
Medical Cond Aggravated by Exposure:RESPIRATORY PROBLEMS CAN BE
INCREASED BY INHALATION OF VAPORS.
First Aid
First Aid:EYES: FLUSH WITH WATER FOR 15 MINUTES. GET IMMEDIATE MEDICAL
ATTENTION. SKIN: REMOVE CONTAMINATED CLOTHING. WASH AFFECTED AREA
WITH SOAP AND WATER. INHALE: MOVE TO FRESH AIR. OBTAIN MEDICAL
ATTENTION IF NEEDED. INGEST: DO NOT INDUCE VOMITING GET IMMEDIATE
MEDICAL AID.
Fire Fighting
Flash Point Method:TCC
Flash Point:45.0F,7.2C
Lower Limits:1.2
Upper Limits:15.8
Extinguishing Media:FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR SELF-CONTAINED BREATHING APPARATUS WITH A
FULL FACE PIECE OPERATED IN PRESSURE-DEMAND WHEN FIGHTING FIRES.
USE WATER FOG NOZZLES TO COOL CLOSED CONTAINER.
Unusual Fire/Explosion Hazard:DO NOT USE WATER. FLAMMABLE LIQUID, CAN
RELEASE VAPORS THAT FORM FLAMMABLE MIXTURE AT TEMP AT OR GREATER
THAN FLASHPOINT. ELIM & ISOLATE FROM IGNITE SOURCES.
Accidental Release
Spill Release Procedures:WEAR RESPIRATOR, ABSORB WITH VERMICULITE OR
OTHER ABSORBENT MATERIAL. ELIMINATE ALL IGNITION SOURCES. STOP
SPILL AT SOURCE AND PREVENT SPREADING.
Handling
Handling and Storage Precautions:STORE IN DRY AREA. KEEP TIGHTLY
CLOSED. PROTECT FROM PHYSICAL DAMAGE. EMPTIED CONTAINERS RETAIN
PRODUCT RESIDUES. OBSERVE PRECAUTIONS STORE BELOW 120F
Other Precautions:STORE LARGE QUANTITIES ACCORDING TO OSHA 1910.106.
KEEP CLOSURE TIGHT & CONTAINER UPRIGHT TO PREVENT LEAKAGE. DO NOT
STORE NEAR HEAT, SPARKS OR FLAME. DO NOT GET IN EYES. KEEP AWAY
FROM CHILDREN. AVOI D SKIN CONTACT. DO NOT TAKE INTERNALLY.
Exposure Controls
Respiratory Protection:IF TLV OF THE PRODUCT OR ANY COMPONENT IS
EXCEEDED, A NIOSH/MSHA APPROVED AIR SUPPLY RESPIRATOR IS ADVISED IN
ABSENCE OF PROPER ENVIRONMENTAL CONTROL. OSHA REGULATIONS ALSO
PERMIT OTHER NIOSH/MSHA RES PIRATORS UNDER SPECIFIED CONDITIONS.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLVS.
Protective Gloves:SOLVENT RESISTANT GLOVES.
Eye Protection:PREFER SPLASH GOGGLES; SAFETY GLASSES
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
CONTACT, WEAR SOLVENT IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:WASH WITH SOAP AND WATER AFTER USE, BEFORE
EATING OR SMOKING.
Supplemental Safety and Health
FOR INDUSTRIAL USE. ENGINEERING OR ADMINISTRATIVE CONTROLS SHOULD BE
IMPLEMENTED FOR SAFETY.
Chemical Properties
Boiling Pt:B.P. Text:179 TO 301F
Vapor Density:> AIR
Spec Gravity:0.9
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR LIQUID, SOLVENT ODOR
Stability
Stability Indicator/Materials to Avoid:YES
AVOID STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT.
Hazardous Decomposition Products:BURNING CAN PRODUCE CARBON DIOXIDE
AND/OR CARBON MONOXIDE.
Disposal
Waste Disposal Methods:DESTROY BY LIQUID INCINERATION. CONTAMINATED
ABSORBENT MAY BE DEPOSITED IN A LANDFILL IN ACCORDANCE WITH
FEDERAL, STATE & LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.